Spohn F5-M34-605 Bedienungsanleitung PDF herunterladen

Spohn Performance, Inc.

494 E Lincoln Ave Myerstown, PA 17067

1-888-365-6064 www.spohn.net

Part# F5-M34-605

Factory Five MK3 & MK4 with 4 Link Rear Suspension

Adjustable Rear Upper Control Arms – Del-Sphere™ Pivot Joints

USE OF THIS PRODUCT IS ACCEPTANCE OF SELLER'S DISCLAIMER OF WARRANTY!

By their very nature, competition components are constantly pushed to their limits. While our components

are designed to withstand intense race conditions, it is impossible to control the quality of installation or

the varying conditions in which they are used. It is for this reason that absolutely no warranty or

guarantee is either written or implied. Neither the seller nor the manufacturer will be liable for any loss,

damage, or injury - direct or indirect - arising from the use of or inability to determine the use of any

product. Before using, the user should determine the suitability of the product for its intended use, and

the user shall assume all responsibility in connection therewith. Spohn Performance, Inc. makes no

guarantee as to the legality for any specific class. Spohn Performance, Inc. makes no claims, nor does it

intend its products to be used in street driven vehicles. Spohn Performance, Inc. reserves the right to

make changes in design or add to or improve on their product without incurring any obligation to install

the same on product previously manufactured. The Buyer agrees to indemnify and hold Spohn

Performance, Inc. harmless from any claim, action or demand arising out of or incident to the Buyer's

installation or use of products purchased from Spohn Performance, Inc.

INSTRUCTIONS

1. Lift rear of vehicle and support by frame rails. DO NOT SUPPORT BY REAR END!

2. Use a floor jack and place under rear axle to support the rear.

3. Remove the rear upper control arm bolts and nuts and remove control arm. The

axle may shift slightly rearward. Replace one control arm at a time.

4. Install the Spohn upper control arm using the jack to help position the rear axle

properly. The Del-Sphere™ end has two spacers on each side. This comes assembled

and wire tied in place so you can see how the assembly is to be installed. Note: The

Del-Sphere™ end is right hand threaded. Make the bolts hand tight only at this time.

Do one side then do the other side.

5. Lower vehicle to ride height (suspension loaded) and tighten all bolts to 72 ft./lbs.

6. One end of the adjuster is left hand threaded and the other end is right hand

threaded. To adjust the length of your control arm loosen both jam nuts and put a

wrench on the adjuster and turn it clockwise or counter-clockwise to lengthen or

shorten the control arm. Once set, tighten the jam nuts. Note: UCAs are shipped jig

set at stock length.

7. Jam nuts are known to work loose over time. To prevent this we recommend that

after you have the UCAs set to your desired length you apply some REMOVABLE

strength (blue) Loctite to the adjuster threads and then tighten up the jam nuts on

each end of the adjuster.

1 2 3

Spohn Performance, Inc 1

Inhaltsverzeichnis

Seite 1 - Spohn Performance, Inc

Spohn Performance, Inc.494 E Lincoln Ave Myerstown, PA 170671-888-365-6064 www.spohn.netPart# F5-M34-605Factory Five MK3 & MK4 with 4 Link Rear

Seite 2

Setting Pinion AngleThere are two angles to deal with:1) Driveshaft angle2) Pinion angleYou subtract pinion angle from driveshaft angle to get TRUE pi

Seite 3

Del-Sphere ™ Pivot Joint Instructions & NotesThe Del-Sphere™ pivot joints are slightly greased for assembly purposes. The bushings inside of

Verwandte Modelle: 614 | 615 | 627G | F5-M34-205 |

Kommentare zu diesen Handbüchern

Keine Kommentare

Spohn F5-M34-605 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Spohn F5-M34-605 herunter. Spohn F5-M34-605 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Verwandte Modelle: 614 | 615 | 627G | F5-M34-205 |

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Spohn F5-M34-605